Information about the dimensions and weight of the device, shown in different measurement units. Body materials, available colors, certifications.
Width
Information about the width, i.e. the horizontal side of the device when it is used in its standard orientation.
77.1 mm (millimeters) 7.71 cm (centimeters) 0.253 ft (feet) 3.035 in (inches)
Height
Information about the height, i.e. the vertical side of the device when it is used in its standard orientation.
155.5 mm (millimeters) 15.55 cm (centimeters) 0.51 ft (feet) 6.122 in (inches)
Thickness
Information about the thickness/depth of the device in different measurement units.
16.2 mm (millimeters) 1.62 cm (centimeters) 0.053 ft (feet) 0.638 in (inches)
Volume
Estimated volume of the device, calculated from the dimensions provided by the manufacturer. Applies for devices in the form of a rectangular parallelepiped.
Information about the colors, in which the device is available in the market.
gray silver
Body materials
Materials used in the fabrication of the device's body.
plastic aluminium alloy
certification
information about the standards, in which the device is certified.
ip68
SIM card
The Subscriber Identity Module (SIM) is used in mobile devices for storing data authenticating the subscribers of mobile services.
SIM card type
Information about the type and size (form factor) of the SIM card used in the device.
micro-sim (3ff - third form factor, since 2003, 15.00 x 12.00 x 0.76 mm)
Number of SIM cards
Information about the number of SIM cards, supported by the device.
2
features
information about some specific features related to the sim card(s) of the device.
dual sim stand-by (both cards are active. when one is busy, the other is not active)
networks
The Subscriber Identity Module (SIM) is used in mobile devices for storing data authenticating the subscribers of mobile services.
GSM
GSM (Global System for Mobile Communications) was developed to replace the analog cellular network (1G), therefore it is referred to as a 2G mobile network. It has been improved with the addition of General Packet Radio Services (GPRS) and later via the Enhanced Data rates for GSM Evolution (EDGE) technology.
gsМ 850 МНz gsМ 900 МНz gsМ 1900 МНz
w-cdma
w-cdma (wideband code division multiple access) is an air interface used by 3g mobile networks. it is one of the three different umts interfaces together with the td-scdma and the td-cdma. the standard provides faster data transfer speeds and allows more users to connect to the network simultaneously.
w-cdma 900 mhz w-cdma 2100 mhz
lte
lte is deemed to be the fourth generation (4g) of mobile communications technology. it has been developed by the 3gpp based on the gsm/edge and umts/hspa technologies in order to increase the speed and capacity of wireless data networks. a further development of the technology is called lte advanced.
Communication between devices within mobile networks is realized via various generations of network technologies, which provide different bandwidth.
Mobile network technologies
There are several network technologies that enhance the performance of mobile networks mainly by increased data bandwidth. Information about the communication technologies supported by the device and their respective uplink and downlink bandwidth.
uМТs gРrs lТЕ Саt 4
operating system
Operating system is the system software, which manages and controls the functioning of the hardware components of the device.
Operating system (OS)
Information about the operating system used by the device as well as its version.
Аndrоid
System on Chip (SoC)
A system on a chip (SoC) includes into a single chip some of the main hardware components of the mobile device.
SoC
The SoC integrates different hardware components such as the CPU, GPU, memory, peripherals, interfaces, etc., as well as software for their functioning.
quаlсоmm snарdrаgоn 210 (МsМ8909)
Process technology
Information about the process technology used in manufacturing the chip. The value in nanometers represents half the distance between elements that make up the CPU.
28 nm (nanometers)
CPU
CPU is the Central Processing Unit or the processor of a mobile device. Its main function is to interpret and execute instructions contained in software applications.
4х 1.0 gНz АrМ Соrtех-А53
CPU bits
The CPU bits are determined by the bit-size of the processor registers, address buses and data buses. 64-bit CPUs provide better performance than 32-bit ones, which on their part perform better than 16-bit processors.
32 bit
Instruction set
The instruction set architecture (ISA) is a set of commands used by the software to manage the CPU's work. Information about the set of instructions the processor can execute.
armv7
Level 2 cache memory (L2)
The L2 (level 2) cache memory is slower than L1, but has a larger capacity, instead, which allows it to cache more data. Just like L1, it is much faster than the system memory (RAM). If the CPU does not find the data needed in L2, it proceeds to look for them in the L3 cache memory (if there is such) or in the RAM.
4
CPU cores
A CPU core is the processor unit, which executes software instructions. Presently, besides single-core processors, there are dual-core, quad-core, hexa-core and so on multi-core processors. They increase the performance of the device allowing the execution of multiple instructions in parallel.
4
CPU frequency
The frequency of the processor describes its clock rate in cycles per second. It is measured in Megahertz (MHz) or Gigahertz (GHz).
1000 mhz (megahertz)
GPU
GPU is a graphical processing unit, which handles computation for 2D/3D graphics applications. In mobile devices GPU is usually utilized by games, UI, video playback, etc. GPU can also perform computation in applications traditionally handled by the CPU.
arm mali-t720 mp2
GPU cores
similar to the CPU, the GPU consists of processing units called cores. They handle the computation of graphics in various applications.
1
RAM capacity
RAM (Random-Access Memory) is used by the operating system and all installed applications. Data in the RAM is lost after the device is turned off or restarted.
2 gb (gigabytes)
RAM type
Information about the type of RAM used by the device.
lpddr2/lpddr3
RAM channels
Information about the number of RAM channels integrated in the SoC. More channels mean higher data transfer rates.
single channel
RAM frequency
RAM frequency relates directly to the rate of reading/writing from/in the RAM memory.
433 mhz (megahertz)
storage
Every mobile device has a built-in storage (internal memory) with a fixed capacity.
Storage
Information about the capacity of the built-in storage of the device. Sometimes one and the same model may is offered in variants with different internal storage capacity.
8 gb (gigabytes)
display
The display of a mobile device is characterized by its technology, resolution, pixel density, diagonal length, color depth, etc.
Type / technology
One of the main characteristics of the display is its type/technology, on which depends its performance.
ips
Diagonal size
In mobile devices display size is represented by the length of its diagonal measured in inches.
5.5 in (inches) 139.7 mm (millimeters) 13.97 cm (centimeters)
Width
Approximate width of the display
2.35 in (inches) 59.8 mm (millimeters) 5.98 cm (centimeters)
Height
Approximate height of the display
4.97 in (inches) 126.25 mm (millimeters) 12.63 cm (centimeters)
Aspect ratio
The ratio between the long and the short side of the display
2.111:1
Resolution
The display resolution shows the number of pixels on the horizontal and vertical side of the screen. The higher the resolution is, the greater the detail of the displayed content.
720 x 1520 pixels
Pixel density
Information about the number of pixels per centimeter (ppcm) or per inch (ppi) of the display. The higher the pixel density, the more detailed and clearer is the information displayed on the screen.
306 ppi (pixels per inch) 120 ppcm (pixels per centimeter)
Color depth
The color depth of the display is also known as bit depth. It shows the number of bits used for the color components of one pixel. Information about the maximum number of colors the screen can display.
24 bit 16777216 colors
Display area
The estimated percentage of the screen area from the device's front area.
63.18 % (percent)
Other features
Information about other functions and features of the display.
capacitive multi-touch
ogs (one glass solution)
Sensors
Different sensors measure different physical quantities and convert them into signals recognizable by the mobile device.
Sensors
Sensors vary in type and purpose. They increase the overall functionality of the device, in which they are integrated.
proximity light accelerometer
Rear camera
The primary camera of the mobile device is usually placed on its back and can be combined with one or more additional cameras.
sensor model
information about the manufacturer and model of the image sensor used by this camera of the device.
sony imx219pq exmor r
Sensor type
Information about the sensor type of the camera. Some of the most widely used types of image sensors on mobile devices are CMOS, BSI, ISOCELL, etc.
cmos bsi (backside illumination)
pixel size
pixels are usually measured in microns (μm). larger ones are capable of recording more light, hence, will offer better low light shooting and wider dynamic range compared to the smaller pixels. on the other hand, smaller pixels allow for increasing the resolution while preserving the same sensor size.
1.124 µm (micrometers) 0.001124 mm (millimeters)
aperture
the aperture (f-stop number) indicates the size of the lens diaphragm opening, which controls the amount of light reaching the image sensor. the lower the f-stop number, the larger the diaphragm opening is, hence, the more light reaches the sensor. usually, the f-stop number specified is the one that corresponds to the maximum possible diaphragm opening.
f/1.8
number of lenses
information about the number of lenses used by the optical system of the camera.
5
Flash type
The rear cameras of mobile devices use mainly a LED flash. It may arrive in a single, dual- or multi-light setup and in different arrangements.
led
Image resolution
One of the main characteristics of the cameras is their image resolution. It states the number of pixels on the horizontal and vertical dimensions of the image, which can also be shown in megapixels that indicate the approximate number of pixels in millions.
3264 x 1200 pixels 3.92 mp (megapixels)
Video resolution
Information about the maximum resolution at which the rear camera can shoot videos.
1280 x 720 pixels 0.92 mp (megapixels)
video fps
information about the maximum number of frames per second (fps) supported by the rear camera while recording video at the maximum resolution. some of the main standard frame rates for recording and playing video are 24 fps, 25 fps, 30 fps, 60 fps.
30 fps (frames per second)
features
information about additional software and hardware features of the rear camera which improve its overall performance.
autofocus continuous shooting digital zoom digital image stabilization geotagging panorama hdr touch focus face detection white balance settings iso settings exposure compensation scene mode
interpolated resolution - 13 mp
Front camera
Modern smartphones have one or more front cameras and their positioning has led to various design concepts – pop-up camera, rotating camera, notch, punch hole, under-display camera, etc.
Field of view
In photography, the Field of view (FoV) depends not only on the focal length of the lens but also on the sensor size. It is derived from the lens's angle of view and the sensor's crop factor. The lens's angle of view is a measure of the angle between the two farthest separated points within the frame measured diagonally. Simply put, this is how much of a scene in front of the camera will be captured by the camera's sensor.
80 ° (degrees)(degrees)
Image resolution
Information about the number of pixels on the horizontal and vertical dimensions of the photos taken by the front camera, indicated in megapixels as well.
2560 x 1920 pixels 4.92 mp (megapixels)
Video resolution
Information about the maximum resolution of the videos shot by the front camera.
1280 x 720 pixels 0.92 mp (megapixels)
audio
Information about the type of speakers and the audio technologies supported by the device.
speaker
the loudspeaker is a device, which reproduces various sounds such as ring tones, alarms, music, voice calls, etc. information about the type of speakers the device uses.
loudspeaker earpiece
radio
The radio in a mobile device is a built-in FM radio receiver.
Radio
Information whether the device has an FM radio receiver or not.
yes
Tracking & Positioning
Information about the positioning and navigation technologies supported by the device.
gРs А-gРs
wifi
Wi-Fi is a technology that provides wireless data connections between various devices within a short range.
Mobile devices support various video file formats and codecs, which respectively store and code/decode digital video data.
Video file formats & codecs
List of some of the most common video file formats and codecs supported standardly by the device.
3gpp (3rd generation partnership project, .3gp) avi (audio video interleaved, .avi) mp4 (mpeg-4 part 14, .mp4, .m4a, .m4p, .m4b, .m4r, .m4v)
battery
The batteries of mobile devices differ in capacity and technology. They provide the electrical charge needed for the functioning of the devices.
Capacity
The capacity of a battery shows the maximum charge, which it can store, measured in mili-Ampere hours.
2500 mah (milliampere-hours)
Type
The battery type is determined by its structure and more specifically, by the chemicals used in it. There are different battery types and some of the most commonly used in mobile devices are the lithium-ion (Li-Ion) and the lithium-ion polymer battery (Li-Polymer).
li-polymer
Features
Information about some additional features of the device's battery.
